Geared 3 Roller Pro Mill Motorized Kit

Product Details

This is the whole kit and caboodle! An entire turn key system for your 5 bbl (or smaller) brewery. Kit consists of the MM-3ProG, Base/Hopper, Gear Motor, Coupler set, Wiring Kit, Gear Motor Base, feeler gauge, and food grade mineral oil. 720lb hour max output with constant feeding will get you brewing for less than the competition. See individual product descriptions for all the details. DO NOT run this mill backwards under any circumstances, you MUST turn the drive shaft ONLY clockwise to feed grain down into the gap. When you purchase our motorized kit the motor will be set up to turn the correct direction.

Geared Grain Mill:

top two rollers both driven by 1215 alloy steel gears
grain driven third roller with fully adjustable gap
three six-inch steel rollers form two gaps, a preliminary fixed gap of approx .070", and a fully adjustable secondary gap
dual eccentric adjusters: 0.028 to .055" secondary gap - milled from solid 6061 billet aluminum
Igus™ bushings on both aluminum knobs to prevent galling
3 x 6" long, 2" diameter 1144 alloy heat treated steel rollers
drill-drive – gear motor drive
12 lbs/minute throughput at 240 rpms
6061-T6 aluminum alloy frames
Oilite™ oil impregnated bronze bushings for the axles
1/2" integral drive shaft standard w/3 flats for drill driving, 2" long outside frame
Optional 1/2” integral drive shaft with 1/8” keyway for direct drive with a coupler
3/8" integral axles

Wooden base and steel hopper for your Monster Mill:

9” Tall 11.5” x 12.75” at the top
11 pound base grain capacity
20 gauge G90 Hot dip galvanized steel construction
CNC Laser cut, and CNC bent
Ships unassembled
Assembles in minutes with included fasteners

1/2 HP Gear Motor:

1/2 HP Capacitor Start / Capacitor Run single phase synchronous AC motor
1825 rpm motor with 10:1 or 7.5:1 gear reduction, and 180 or 240 rpm output
110 or 220 V
Reversible
22 mm output shaft with 6 mm keyway
Shaft height matches our new MM-3ProG geared mill with no adjustments needed
Made in Taiwan

Coupler:

TB Woods L075 series couplers halves
One half with 1/2” bore and keyway
One half with 22mm bore and 6mm keyway
Urethane jaw spider coupling insert

Gear Motor Wiring Kit

18” aluminum conduit with proper steel retainer ends, one straight, and one 90°
Super flexible 64 strand hookup wire with proper black, white and green XTFN insulation
Krimpa-Seal™ heat seal spade connectors on all wire ends
Metal switch box
Commercial grade single pole switch
Stainless steel face plate
10-foot long 12 gauge super flexible grounded power cord with 110V-12P plug

Gear Motor Base
Feeler Gauge
Food Grade Mineral Oil

Product Reviews

Write your own review