Geared 3 Roller Pro Mill Motorized Kit

• top two rollers both driven by 1215 alloy steel gears
• grain driven third roller with fully adjustable gap
• three six-inch steel rollers form two gaps, a preliminary fixed gap of approx .070", and a fully adjustable secondary gap
• dual eccentric adjusters: 0.028 to .055" secondary gap - milled from solid 6061 billet aluminum
• Igus™ bushings on both aluminum knobs to prevent galling
  
• 3 x 6" long, 2" diameter 1144 alloy heat treated steel rollers
• drill-drive – gear motor drive
• 12 lbs/minute throughput at 240 rpms
• 6061-T6 aluminum alloy frames
• Oilite™ oil impregnated bronze bushings for the axles
• 1/2" integral drive shaft standard w/3 flats for drill driving, 2" long outside frame
• Optional 1/2” integral drive shaft with 1/8” keyway for direct drive with a coupler
• 3/8" integral axles

• 9” Tall 11.5” x 12.75” at the top
• 11 pound base grain capacity
• 20 gauge G90 Hot dip galvanized steel construction
• CNC Laser cut, and CNC bent
• Ships unassembled
• Assembles in minutes with included fasteners

• 1/2 HP Capacitor Start / Capacitor Run single phase synchronous AC motor
• 1825 rpm motor with 10:1 or 7.5:1 gear reduction, and 180 or 240 rpm output
• 110 or 220 V
• Reversible
• 22 mm output shaft with 6 mm keyway
• Shaft height matches our new MM-3ProG geared mill with no adjustments needed
• Made in Taiwan

• TB Woods L075 series couplers halves
• One half with 1/2” bore and keyway
• One half with 22mm bore and 6mm keyway
• Urethane jaw spider coupling insert

Gear Motor Wiring Kit

• 18” aluminum conduit with proper steel retainer ends, one straight, and one 90°
• Super flexible 64 strand hookup wire with proper black, white and green XTFN insulation
• Krimpa-Seal™ heat seal spade connectors on all wire ends
• Metal switch box
• Commercial grade single pole switch
• Stainless steel face plate
• 10-foot long 12 gauge super flexible grounded power cord with 110V-12P plug